Cisco Wap581 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} Cisco Wap581에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Wap581 14 페이지. Reboot and reset to factory default settings
Cisco Wap581에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 매뉴얼 (10 페이지)

페이지 인쇄

Bad Image

After a new firmware installation, if the Power light is solid red, contact

system support; see

Incorrect IP Address

The most likely cause of connectivity failure is an incorrect IP address. The

Web browser may be pointing to the wrong IP address, or your computer

may be configured with an IP address that is not in the same subnet as the

device.

Because the factory default IP address configuration is DHCP, make sure

that your DHCP server is running and can be reached. You may need to

disconnect and reconnect the devices for them to discover their new IP

addresses from the DHCP server. You can then query the DHCP server for

the new IP address. See

Configuration

for more information on how to find the DHCP address.

If the wireless access points do not receive a DHCP response (there is no

DHCP server on your network) after 60 seconds, the access points will

fallback to the following default static IP address: 192.168.1.245 and a

default mask of 255.255.255.0. To reach that IP address, be sure that your

computer is on the 192.168.1.xxx network.

Rebooting the Devices or Returning them

to their Factory Default Settings

To reboot your device:

• The Cisco WAP581 uses PoE power supply; unplug your PoE port

Ethernet connection for three seconds and plug it back in.

• With the power on, press the Reset button with an opened paper clip

for less than three seconds, or until the lights go off.

–

When all the lights go off, release the Reset button.

–

Release the Reset button as soon as the lights go off, or you will

restore the device to factory default settings and lose your

configurations.

To reset the device to factory default settings:

With the power on, press and hold the Reset button with an opened paper

clip for more than 10 seconds. The system light will go off.

Cisco WAP581 Wireless Access Point

Where to Go from

Step 2

Getting Started with the

Here.