Cisco Wap581 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Wap581에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Wap581 17 페이지. Reboot and reset to factory default settings
Cisco Wap581에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지), 매뉴얼 (10 페이지)

페이지 인쇄

Suggested Next Steps

Smart Power Source

Smart PoE is designed for detecting the power level from the PSE (Power Sourcing

Equipment) side; it does not matter whether 802.3at or 802.3af mode, the WAP581

will operate at the appropriate mode automatically.

Smart PoE ensures that the WAP581 remains functional once powered by 802.3af

PSE, and intelligently to adjust operations below:

• Second Ethernet port disabled

• 2.4-GHz 802.11n radio in 2x2:2 spatial-stream mode

• 5-GHz 802.11ac radio operates without restrictions

In case of an error while installing, try the following troubleshooting procedures

described in this section:

Troubleshooting

If you cannot display the configuration utility, you can test the ability of the

computer to communicate with the device by using ping.

To use ping on a computer running Windows:

Verify that the Cisco WAP581 is powered on and the lights indicate the

TEP

appropriate links.

Locate the device's IP address. While there are different ways to locate your

TEP

device's IP address, this procedure uses Cisco FindIT.

If you have previously downloaded Cisco FindIT, open Internet

Explorer and launch Cisco FindIT. For more information on

downloading Cisco FindIT, see www.cisco.com/go/findit.

b. In the Cisco FindIT display, place your mouse over the device's name.

The device IP address is displayed along with other device

information.

Open a command window by choosing Start > Run and enter cmd.

TEP

At the command window prompt, enter ping and the device IP address. In this

TEP

example, we pinged 192.0.2.10.

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data: Reply

from 192.0.2.10: bytes=32 time<1ms TTL=128

Cisco WAP125 Quick Start Guide