CABINETS TO GO Findley & Myers BC33 조립 지침 매뉴얼 - 페이지 2
{카테고리_이름} CABINETS TO GO Findley & Myers BC33에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CABINETS TO GO Findley & Myers BC33 9 페이지. Base cabinets
CABINETS TO GO Findley & Myers BC33에 대해서도 마찬가지입니다: 조립 지침 (5 페이지)
페이지 인쇄
►General Instructions:
Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed
to face the test of daily use and guaranteeing your enjoyment for many years to come.
Carefully read the instructions before starting the installation.
During assembly, please follow all generally accepted safety procedures.
Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any
damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant
damage and/or injury.
Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist.
Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will
not be held responsible for failure to follow these instructions.
PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE
QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT 1-800-
CABINET.
► Items Quantity
Item
Description
A
Left Side Panel
B
Right Side Panel
C
Back Panel
D
Bottom Panel
E
Frame & 2 Doors
F
Shelf
G
Toe Kick
H
Drawer Panel & Drawer Box: (Front, Back, Sides, & Bottom)
I
Drawer Glides
Hardware Box
Bumper 6pcs, Shelf Bracket 4pcs, 1/2" Round Head Screws 20pcs, Plastic Corner Brackets 4pcs, 1" Flat Head Screws 4pcs, Glide Brackets 2pcs, Drawer Clips 2pcs
► Required tools:
Tools Required: Phillips Screwdriver
Optional Tools: Electric Drill
► Hardware Box:
a
b
c
d
4
t
8
Qty
4
Q ty
Q
y
Qty
20
The materials listing above are for the largest unit in this instruction set. Smaller units may require less hardware and materials;
therefore, your item may contain a smaller number of each.
Optional Tools: Rubber Mallet
e
f
g
t
Q ty
Q
y
4
Qty
2
2
Page 2
Qty
1
1
1
1
1
1
1
1 Set
1 Set