Cisco WS-C3550-12G 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Cisco WS-C3550-12G에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-C3550-12G 35 페이지. 3500 series lightweight access point
Cisco WS-C3550-12G에 대해서도 마찬가지입니다: 데이터시트 (19 페이지)

페이지 인쇄
Cisco WS-C3550-12G 시작하기 매뉴얼

Pre-Installation Configuration Setup

Figure 3 shows the pre-installation configuration setup.
Figure 3
Pre-Installation Configuration Setup
Follow these steps to perform the pre-installation configuration.
Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
Step 1
the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate
Cisco wireless LAN controller guide.
a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management and AP-Manager Interface.
b. Configure the switch to which your access point is to attach. See the Cisco Unified Wireless
Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional
information.
c. Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
d. Make sure DHCP is enabled on the network. The access point must receive its IP address
through DHCP.
10
Controller
Layer 3
devices
Cisco Aironet
access points