CABINETS TO GO Findley & Myers DC230 조립 지침 - 페이지 3
{카테고리_이름} CABINETS TO GO Findley & Myers DC230에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CABINETS TO GO Findley & Myers DC230 5 페이지. 2 drawer base cabinet
CABINETS TO GO Findley & Myers DC230에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (8 페이지)
페이지 인쇄Instructions:
►
1.
Place the face frame (A) face down on a flat soft working surface to ensure that the face is
not scratched or damaged (Figure 1).
2.
Installing the Side Panels (Figure 2): Insert right and left side panels (B) into the grooves of
the face frame (A) and align the cam lock connectors (Figure 2). Lock the cam
with a screw driver by turning the screw 180° clockwise (Figure 4).
3.
Installing the Bottom (Figure 3): Gently spread the side panels and insert t he bottom (C)
into the grooves of side panels (B) until it is seated in the face frame (A). Align it and lock each cam.
4.
Installing the Back Panel and Toe Kick (Figure 5): Before you start this step, place the
back panel (D) on a flat surface facing upward. Install the drawer rail holders (f) in the pre‐
spotted area on the back panel (Figure 6). Secure them with 2 flat head screws (e) (Figure 6). Then
put the back panel (D) at rear of side panels (B) (Figure 5). Align and lock each cam lock. Install the
Toe Kick (E) by locking the cam lock at both ends (Figure 5).
e
f
4
8
Qty
Qty
A
Figure 1
B
B
Figure 2
C
B
B
Figure 3
D
B
E
Figure 5
Page 3
f
e
D
Figure 6
Figure 4
Top
f