Cisco WS-C3550-12T 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Cisco WS-C3550-12T에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-C3550-12T 35 페이지. 3500 series lightweight access point
Cisco WS-C3550-12T에 대해서도 마찬가지입니다: 데이터시트 (19 페이지)

페이지 인쇄

You can mount the access point above a suspended ceiling but you must purchase

Note

additional mounting hardware: See "Mounting the Access Point" section on page 13 for

additional information.

• Access point power options: power supplied by the recommended external power supply (Cisco

AIR-PWR-B), a DC power supply, PoE from a network device, or a PoE power injector/hub

(usually located in a wiring closet).

Note

Access points mounted in a building's environmental airspace must be powered using PoE

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the

device MAC addresses from each location and return them to the person who is planning or managing

your wireless network.

Installation Summary

Installing the access point involves these operations:

• Performing a pre-installation configuration (optional)

• Mounting the access point

• Grounding the access point

• Deploying the access point on the wireless network

Performing a Pre-Installation Configuration

The following procedures ensure that your access point installation and initial operation go as

expected. A pre-installation configuration is also known as priming the access point. This procedure

is optional.

Performing a pre-installation configuration is an optional procedure. If your network

Note

controller is properly configured, you can install your access point in its final location and

connect it to the network from there. See the "Deploying the Access Point on the Wireless

Network" section on page 13 for details.