Cisco WUMC710 사용자 설명서 - 페이지 7

{카테고리_이름} Cisco WUMC710에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WUMC710 17 페이지. 802.11ac
Cisco WUMC710에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 빠른 설치 매뉴얼 (17 페이지)

페이지 인쇄

1. Setup > Basic Setup

Linksys WUMC710

Advanced Configuration

After setting up the bridge by following the steps on the CD folder, the bridge

will be ready for use However, if you want to change its advanced settings,

use the bridge's browser-based utility This chapter describes each web page

of the utility and each page's key functions You can access the utility via a web

browser on a computer networked with the bridge

The browser-based utility has these main tabs: Setup, Wireless, Administration,

and Status Additional tabs will be available after you click one of the main tabs

How to access the browser-based utility

Use a web browser to access the browser-based utility

If the bridge is connected to a network with a DHCP server (usually the network

router), then the bridge will obtain its IP address from the DHCP server If

there is no DHCP server, then the bridge will use its default static IP address,

10.100.1.1 (If you set a permanent static IP address on the bridge through the

browser-based utility, then enter the static IP address instead )

NOTE

If you do not know the bridge's IP address, then find its IP

address in the DHCP clients table of your router (Refer to the

documentation for your router )

If you cannot locate the bridge's IP address, you can reset the

bridge; press the Reset button on the bridge for approximately five

seconds, using a straightened paper clip This will reset the bridge

back to the factory default settings The bridge will request an IP

address from the DHCP server (usually the network router) If no

DHCP server is found, then the bridge will use its default static IP

address, 10.100.1.1, until it detects a DHCP server and is assigned a

dynamic IP address

Launch your web browser, and enter the Adapter's IP address (the default

setting is 10.100.1.1)in the Address field Press Enter

A password request screen appears (Non-Windows XP users will see a similar

screen ) Leave the User name field blank Enter the password you created

during the Setup Wizard If you did not create a new password, use the default

password admin (You can set a new password from the Administration >

Management screen ) Click OK to continue

NOTE

If the password request screen does not appear, wait two minutes

and try again

Setup > Basic Setup

The first screen that appears is the Basic Setup screen Use this screen to change

the browser-based utility's language, or to change the bridge's wired, Ethernet

network settings

Advanced Configuration