Cisco 3515 MCU12 설치 및 업그레이드 매뉴얼 - 페이지 13

{카테고리_이름} Cisco 3515 MCU12에 대한 설치 및 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3515 MCU12 44 페이지. Cisco unified videoconferencing releases 5.6 and 5.7

페이지 인쇄

Setting Up Your Cisco Unified

Videoconferencing 3515 MCU

•

Physical Description

Each Cisco Unified Videoconferencing 3515 MCU unit internally contains two cards:

•

The two cards work together to perform audio and videoconferencing, but each card requires a unique

IP address. The cards communicate with each other using IP as the backbone.

Note

For correct operation, the EMP card must register with the MCU.

This section provides a physical description of the Cisco Unified Videoconferencing 3515 MCU12 and

Cisco Unified Videoconferencing 3515 MCU24 units.

The Cisco Unified Videoconferencing 3515 MCU unit has a 10/100BaseT Ethernet port on the front

panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial-port

that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1

describes the components of the front panel.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7

OL-17012-01

Physical Description, page 2-1

Verifying the Package Contents, page 2-2

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack, page 2-3

How to Perform the Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration,

page 2-4

How to Perform the Video Processing Module Initial Configuration, page 2-8

About Managing and Monitoring the Cisco Unified Videoconferencing 3515 MCU Unit, page 2-13

Accessing the Cisco Unified Videoconferencing 3515 MCU Administrator Interface, page 2-13

Registering the Online Help for the 3515 MCU, page 2-15

Signaling and audio card (MCU—the upper card)

Video processing card (EMP—the lower card)

shows the front panel of the Cisco Unified Videoconferencing 3515 MCU unit.

C H A P T E R

Table 2-1

2-1