Cisco 3515 MCU24 설치 및 업그레이드 매뉴얼 - 페이지 16

{카테고리_이름} Cisco 3515 MCU24에 대한 설치 및 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3515 MCU24 44 페이지. Cisco unified videoconferencing releases 5.6 and 5.7

Cisco 3515 MCU24 설치 및 업그레이드 매뉴얼

How to Perform the Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration

Figure 2-2
Pass the screws through the brackets and tighten them into the screw holes on each side of the
Step 4
Cisco Unified Videoconferencing 3515 MCU unit using a suitable screwdriver.
Insert the Cisco Unified Videoconferencing 3515 MCU unit into the 19-inch rack.
Step 5
Fasten the brackets to the side rails of the rack.
Step 6
Make sure that the air vents at the sides of the Cisco Unified Videoconferencing 3515 MCU unit are not
Step 7
blocked.
How to Perform the Cisco Unified Videoconferencing 3515 MCU
Unit Initial Configuration

About the Initial Configuration and Boot Phases

Initial monitoring and administration of the Cisco Unified Videoconferencing 3515 MCU unit are
performed from a remote PC via a serial connection. This allows you to access the boot configuration
menu of the Cisco Unified Videoconferencing 3515 MCU unit. At power-up, the Cisco Unified
Videoconferencing 3515 MCU unit goes through the following boot phases:
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
2-4
Fitting a Bracket for Rack Mounting
About the Initial Configuration and Boot Phases, page 2-4
Connecting to a PC, page 2-5
Setting the IP Address, page 2-5
Setting Ethernet Speed and Duplex Parameters, page 2-7
Connecting the Cisco Unified Videoconferencing 3515 MCU Unit to the LAN, page 2-8
Auto-boot—The embedded operating system initializes and displays basic information.
Configuration menu—A six-second countdown allows you to enter the configuration menu.
Initialization—The Cisco Unified Videoconferencing 3515 MCU unit completes its boot sequence
and is ready for operation.
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
OL-17012-01