Epson ePhoto 307 설정 매뉴얼

{카테고리_이름} Epson ePhoto 307에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ePhoto 307 2 페이지. Epson stylus photo rx510: install guide

페이지 인쇄

Setup

4047356-00

XXX

Cautions and Notes

Cautions must be observed to avoid damage to your

equipment.

Notes contain important information and useful tips on the

operation of this product.

Unpacking

Make sure the following parts are included and not damaged.

feeder guard

film holder

paper support

ink

power cord

cartridges

The contents may vary in certain locations.

The power cord comes attached in some countries.

Removing Protect

Material

Pick up the protective material and install it in the secure position

following the Notice Sheet. Make sure the protective material

around the ink cartridges are removed.

Unlocking

Open the document cover and slide the transportation lock lever.

Attaching the Parts

1. Attach the paper support.

2. Connect the document cover's cable to the TPU interface

connector.

Turning On

Plug in the power cord and press the P On button to turn on this

product.

CD-ROM

Press

Note:

Do not connect this product to your computer before step

or you will fail to install the software.

Installing Ink Cartridges

1. Open the scanner unit.

2. Open the cartridge cover.

3. Remove an ink cartridge from its package.

Do not touch

4. Place each cartridge into its holder. Then, push the ink cartridge

down until it clicks into place and close the cartridge cover.

Note:

Install all ink cartridges. This product does not work unless all

cartridges are installed properly.

5. Lower the scanner unit.

Ink charging starts and it takes about two minutes to complete.

Initial charge... appears on the LCD panel and this product

produces a variety of mechanical sounds. This is normal.

Caution:

Never turn off this product during the ink charging process.

Do not load paper until ink charging is complete.

Selecting a Language

1. Press the Setup button and

A button until 6.Languages

appears on the LCD panel

and then press the x Color

button.

2. Select a language by

pressing the D button.

3. Press the OK button.

Menu items appear in the

selected language.

Loading Paper

1. Open the output tray.

2. Move the feeder guard towards you.

3. While holding down its locking tab, slide out the edge guide.

4. Load the stack of paper with the printable side facing up and

resting against the guide of feeder guard.

guide

5. Stand the stack of paper against the paper support.

6. Move the feeder guard back.

Now you are ready to use this product as a stand-alone device.

See the next section to learn how to make a test copy. If you want

to install software, see "Connecting to Your Computer" on the

reverse side of this sheet.

Making Copies

1. Place a document on the document table.

2. Press the Copy Mode button to enter the Copy Mode.

Printed in XXX XX-XX.XX