Epson ET-16500 빠른 시작 매뉴얼
{카테고리_이름} Epson ET-16500에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ET-16500 4 페이지.
페이지 인쇄
ET-16500
Start Here
Read these instructions before using your product.
Nota para hispanohablantes/Note for Spanish speakers:
obtener instrucciones de confi guración en español, consulte la Guía
de instalación en www.epson.com/support/et16500sp (requiere una
conexión a Internet).
1
Unpack
Note:
• Your product includes 4 Initial ink bottles that are designed for
product setup and 4 additional full-size bottles for refilling. These
bottles are not for resale.
• Do not open the ink bottles until you are ready to fill the ink tanks.
The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution:
Do not touch the translucent part or ink tubes.
3
Lower the scanner unit.
Para
French control
panel stickers
2
Fill ink tanks
Note:
This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper or plastic under the ink tank when
you fi ll or refi ll the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank unit cover, then remove the cap for the
black ink tank and attach it to its holder.
2
Unpack the black Initial ink bottle.
3
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
4
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color-coded sticker above the ink tank unit to
identify the color of each tank.
Caution:
Be sure to fi ll each tank with the correct color.
5
Carefully seal the bottle using the reverse side of the bottle
tip for proper disposal.