Cisco 7936 - IP Conference Station VoIP Phone 전화 매뉴얼 - 페이지 14
{카테고리_이름} Cisco 7936 - IP Conference Station VoIP Phone에 대한 전화 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7936 - IP Conference Station VoIP Phone 49 페이지. Ip phone conference station
Cisco 7936 - IP Conference Station VoIP Phone에 대해서도 마찬가지입니다: 시스템 매뉴얼 (50 페이지), 시스템 매뉴얼 (36 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 참조 매뉴얼 (2 페이지)
페이지 인쇄
Connect the power supply unit to the AC adapter port on the PIM, and plug the other end
Step 4
into a standard electrical power outlet in the wall.
If you are using the External Microphone Kit, connect each of the microphone extensions to
Step 5
the microphone jacks installed on the bottom of the
Cisco Unified IP Conference Station 7936. See Figure 2 for an illustration of this connection.
Tip
If you do not correctly connect the cables, PIM, power supply, and the microphone extensions,
the IP Conference Station will not work.
Use of non-Cisco-certified components may not work and may void the IP Conference Station
product warranty.
Startup Sequence
During the startup sequence, the LCD screen display shows the following messages.
Sequence Step
Startup—The startup process occurs about
15 seconds after power up.
Configuring IP address—These messages appear
when the protocol is configuring the IP address.
TFTP configuration—This message appears when
connectivity is established with the TFTP server.
Cisco Unified CallManager configuration—This
message appears when connectivity is established
with the Cisco Unified CallManager.
Cisco Unified CallManager registration—This
message appears while the device is registering
with the Cisco Unified CallManager.
Initialization complete.
14
LCD Screen Message Display
Cisco Systems, Inc.
Polycom Technology
Copyright 2003
Configuring IP
Press Menu to Reconfigure
Station IP: IP address
Contacting: TFTP Server
Opening: Cisco CallManager IP address
Registering
Press the Phone Key to get a dial tone