Digitax F2RTC 기술 매뉴얼 - 페이지 13

{카테고리_이름} Digitax F2RTC에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitax F2RTC 20 페이지.

페이지 인쇄

Statistical Memory

How to Erase the Statistical Memory Content

The taximeter records and keeps data in 2 Memory Blocks, each one divided in 45 locations.

The content of both Block1 and Block2 can be erased (if allowed by the setup).

Select For Hire position.

Press K1 and K2 at the same time to enter in the "Statistical

Reading " mode.

Now the sign "FOR HIRE" starts blinking.

Reach location n. 6 by pressing K2 button.

Reaching location n. 6, press K4 button to erase all

information contained in Block 1.

For Hire sign stops blinking for few seconds.

Press OP button to end the erasing procedure and go back to

For Hire position.

Select For Hire position.

Press K1 and K2 at the same time to enter in the "Statistical

Reading " mode.

Now the sign "FOR HIRE" starts blinking.

Reach the memory location n. 7 by pressing K2 button.

Reaching location n. 7, insert the Black Programming Key and

press K4 button to erase all information contained in Block 2.

For Hire sign stops blinking for few seconds.

Press OP button to end the erasing procedure and go back to

For Hire position.

Advanced Functions enabled by the Black Programming Key

Loc.

Memory Content

Total Reset and Load all the Factory Parameters

Erase Memory Block 2

The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confidential. Any disclosure, copying, distribution to third

party is strictly prohibited.

ERASING PROCEDURE FOR BLOCK 1

ERASING PROCEDURE FOR BLOCK 2