Cisco Cisco Access Registrar 4.2 네트워크 설정 구성 - 페이지 21
{카테고리_이름} Cisco Cisco Access Registrar 4.2에 대한 네트워크 설정 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Cisco Access Registrar 4.2 34 페이지. Telepresence conference system
Cisco Cisco Access Registrar 4.2에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (46 페이지)
페이지 인쇄
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
Step 6
Step 7
Assigning a Subnet Mask
Using the Phone Configuration Web Page
Step 1
Step 2
Step 3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
OL-8617-01
Press Validat.
Press Save.
The subnet mask is used to partition the IP address into a network and a host
identifier. The subnet mask is used to mask a portion of the IP address so that
TCP/IP can distinguish the network ID from the host ID.
Before you can assign a subnet mask, you must disable DHCP. For instructions,
see the
"Disabling DHCP" section on page
To assign a subnet mask for the Cisco Unified IP Phone, follow these steps:
Procedure
Display the Phone Configuration web page.
For instructions, see the
Configuration Web Page" section on page
In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
To set the subnet mask, enter an address in the StaticNetMask field and click
Apply.
4-15.
"Accessing Network Settings through a Phone
4-2.
Configuring IP Settings
4-21