Cisco EX90 사용자 설명서 - 페이지 23

{카테고리_이름} Cisco EX90에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco EX90 37 페이지. Telepresence system
Cisco EX90에 대해서도 마찬가지입니다: 사용자 설명서 (50 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (49 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 매뉴얼 (42 페이지), 사용자 설명서 (45 페이지), 설치 매뉴얼 (6 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (7 페이지), 문제 해결 매뉴얼 (37 페이지), 설치 매뉴얼 (2 페이지), 사용자 설명서 (45 페이지), 사용자 설명서 (37 페이지), 시작하기 매뉴얼 (46 페이지)

Cisco TelePresence System EX90

Contents

Introduction

Setting the EX90 in standby

Outside a call, you may have the unit enter standby mode by touching the Power

button on the main unit (the screen). The Standby dialog is displayed and the unit

enters standby immediately. This does not work when you are in a call.

Shutting down the EX90

Outside a call, press the Power button until the Shutdown progress bar is filled

completely.

Release the button and the unit will go in shutdown in just a few seconds.

D14724.03

User guide EX90, November 2010.

Connecting the EX90

Using the EX90

Tap as shown to wake

up the system from

standby.

To start the system again,

press the Power button

until the LED illuminates

(green light).

The settings

Reverting to factory default settings

To revert to the factory default settings, do as follows:

Disconnect the power cord.

Reconnect the power cord—a green light will illuminate shortly after.

Press the Power button as soon as the green light appears. Keep it de-

pressed for 15 seconds or so, until the green light starts flashing.

Release the button and press twice within 2 seconds. All settings will now

revert to factory default settings.

Changing background image on touch screen

The background image on the touch screen can be changed.

Do as follows:

Draw a circle with your finger anywhere on the screen where there are no

icons.

The below image will then appear on the touch screen screen. Tap one of the

small images to use it as background image.

User guide

Web interface