Argo AW726HLF 사용 설명서 - 페이지 8
{카테고리_이름} Argo AW726HLF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo AW726HLF 16 페이지.
페이지 인쇄
SETTING THE 1 HOUR TIMER
This function causes the unit to operate for one hour at the
set conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
Press four times the TIMER SEL
l
button.The 1 HOUR TIMER mark will
appear on the display.
CANCELLATION PROCEDURE
Press the ON/OFF button to turn the air conditioner off.
l
GB
Wait for the indoor unit to stop operating.
l
Press the ON/OFF button again to turn the air conditioner
l
on.
ADJUSTING THE AIR FLOW DIRECTION
HORIZONTAL (manual) - Only for AW-FC models
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
AW MODELS
Vertical vane
FC MODELS
VERTICAL VANE
VERTICAL (with remote control unit)
Press the FLAP button to select the flap function:
Fixed:
six
position
Right
Left
Continous
Automatically
oscillations
oscillations
The flap automatically closes when the unit
l
NOTES
is off.
When the unit starts in heating operation,
l
4
the fan speed will be low and the flap will be
in the
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
Use the FLAP button on the remote control to adjust
l
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
Do not have the flap pointed down during cooling
l
operation. Condensation may begin to form around the
air vent and drip down.
AW MODELS
Air outlet
grille
FC MODELS
AS MODELS
FLAPS
8
position until the air being blown
Up
Flap
Down
DEFLETTORE