Cisco MX Series 시작하기 매뉴얼 - 페이지 20

{카테고리_이름} Cisco MX Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MX Series 33 페이지. Telepresence video systems
Cisco MX Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 시작하기 매뉴얼 (34 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄

Cisco TelePresence Video Systems



Introduction

On-screen setup assistant when using a remote control

The on-screen setup assistant is available for SX10 and SX20

when you are using a remote control. When you start the

system for the first time, the setup assistant starts

To be able to make calls your system needs an IP address

and it needs to be registered to a service. If your system is

automatically provisioned, the IP and provisioning settings

presented in this chapter are automatically configured.

Access the settings after initial setup

Navigate to the gearwheel icon in the upper left corner on the

home screen and press

on the remote control.

Navigate to

System Information >

Settings. Select the setting

you wish to change.

No image on screen

If the menu doesn't show up on the screen:

•

Make sure the monitor is connected and has been

switched on.

•

Make sure that the correct input is selected on the monitor.

•

Make sure the remote control has batteries installed.

•

Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If you still can't see the on-screen menu, make sure the

monitor cable is connected to the video output connector. If in

doubt, see the installation guide for your product.

NOTE:

This guide doesn't cover information on Cisco Spark

registered systems. For more information on Cisco Spark

room systems, visit:

https://help.webex.com/community/cisco-cloud-collab-mgmt

D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.

User interfaces

Web interface

automatically.

On-screen setup assistant

Getting Started Guide

Touch

Appendices