Cisco MX200 G2 시작하기 매뉴얼 - 페이지 38

{카테고리_이름} Cisco MX200 G2에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MX200 G2 46 페이지. Wall mount
Cisco MX200 G2에 대해서도 마찬가지입니다: 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (7 페이지), 설치 매뉴얼 (8 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지)

페이지 인쇄

Cisco TelePresence Video Systems

Contents

Call key

Press the Call key to place a

call, and to accept an incom-

ing call.

Use the Call button as a short-

cut to Recent Calls when the

Call menu is not visible.

Clear

Press the Clear key to remove

characters in a text field.

Waking up the system

To wake up the system just pick up the remote control or press any key. You may have to point

the remote control toward the system/camera to make sure it discovers you.

Home key

Press the

Home

(

) key

to open the Home menu

on screen.

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

End call / Standby

Press the End Call key to

reject an incoming call, to

end an ongoing call or—when

idle—to go into standby mode.

When navigating in the menu

the key is used to exit the

menu system.

Press and hold this key to

have the system enter standby

mode.

Rubber line sensors

When you pick up the remote

control and touch the rubber

line sensors along the sides of

the remote control, the system

wakes up.

Configuration

Alphanumeric keypad

The keypad behaves in a similar way to the keypad on a mobile phone.

0-9, a-z, period (.), @,

space, *

Press a key repeatedly

to toggle between the

options displayed on that

key.

IR sensor range (DIP switch setting)

The IR sensor has a short and long range. When video conference systems are placed close to each

other, you may find it convenient to use the short range to avoid interfering with the other systems.

Open the battery cover and remove the batteries to set the DIP switch.

• Short range (1 m / 3 ft): Move the DIP switch down.

•

Long range: Move the DIP switch up.

The DIP switch

Getting Started Guide

Appendices

Contacts

Press and hold the # key

to toggle between lower

and upper case characters

and numbers (depending

on context).

abc/123 #