DigiTech BRIAN MAY RED SPECIAL PEDAL 소유자 매뉴얼 - 페이지 14

{카테고리_이름} DigiTech BRIAN MAY RED SPECIAL PEDAL에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech BRIAN MAY RED SPECIAL PEDAL 18 페이지.

Connections Diagram -

Flexible Output Mode

3 (Stereo Amp)

AMPLIFIER

PS0913B

FS3X FOOTSWITCH

(OPTIONAL)

Calibrating the Expression Pedal

If the Expression Pedal's range becomes diminished over time, it may be

necessary to re-calibrate the pedal. Here is the procedure for calibration:

1. Begin with the power disconnected from the Red Special Pedal.

2. Select Model 1 using the MODEL knob.

3. Insert a standard mono (TS) guitar cable into the FOOTSWITCH

jack.

4. Connect the power supply to the Red Special Pedal. The INDICA-

TOR LED begins flashing yellow.

5. Rock the EXPRESSION PEDAL forward (toe down).

6. Select Model 2 using the MODEL knob. Wait for the INDICATOR

LED to begin flashing green.

7. Rock the EXPRESSION PEDAL back (toe up).

8. Select Model 3 using the MODEL knob. The INDICATOR LED

should flash green three times if calibration was successful.

If the calibration procedure fails, the INDICATOR LED will flash red

instead of green during step 8 and the unit will not return to normal

operation until the Expression Pedal has been properly calibrated. Select

Model 1 using the MODEL knob at this time and repeat steps 5-8 until

Expression Pedal calibration is successful.