Cisco Profile Series 사용자 설명서 - 페이지 2

{카테고리_이름} Cisco Profile Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Profile Series 7 페이지. Jbod on the 12g sas modular raid controller
Cisco Profile Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 매뉴얼 (44 페이지), 구성 매뉴얼 (13 페이지), 설치 시트 (2 페이지), 설치 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (16 페이지), 시작하기 매뉴얼 (32 페이지), 매뉴얼 (16 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

Getting Started

The Cisco C Series (formerly Tandberg) units provide high definition video

conferencing facilities. They can be used in a number of different configurations

including mobile carts, large TV systems or room based projector systems.

Although the control of the televisions or projectors will vary from system to

system, the basic control of the video conferencing unit will be the same.

On fixed systems, it is likely that the unit is

fully connected, switched on and left in a

standby mode.

On system using a projector, there may be

a room control panel that is used to turn

on the projectors.

If you are unsure how to turn on the

system please refer to site specific

documentation, or contact your support

team.

Cisco C20 Codec

If using a mobile system, it may

be necessary to connect the

system to the power supply

and computer network.

Simply connect the power cord

to a socket and connect the

data cable to the appropriate

data point.

In general, systems used for

video conferencing need to be

plugged into specially

configured data points. If you

need to connect the system in

an areas not previously set-up

please contact a member of

your support team.

Having connected the power supply, it may be necessary to switch on the codec

and the display. The power switch for the video conferencing unit is normally

located at the back left of the unit. Depending on the model this is either a push

button or a rocker switch.

You may also need to turn on the TV. Use the button on the remote control.

Please note that some displays also have a power switch tucked away on the

rear of the unit.

Rear of the C20 Codec

Data

Connection

Power Switch