Cisco Profile Series 구성 매뉴얼 - 페이지 3

{카테고리_이름} Cisco Profile Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Profile Series 13 페이지. Jbod on the 12g sas modular raid controller
Cisco Profile Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 사용자 설명서 (7 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 매뉴얼 (44 페이지), 설치 시트 (2 페이지), 설치 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (16 페이지), 시작하기 매뉴얼 (32 페이지), 매뉴얼 (16 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

Cisco Profile Series 구성 매뉴얼
Chapter 4
Configuring the Serial Interface
Table 4-2
LED Name
CONN
LOOP BACK

Information About Configuring Serial Interfaces

To configure serial interfaces, you should understand the following concept:

Cisco HDLC Encapsulation

Cisco High-Level Data Link Controller (HDLC) is the Cisco proprietary protocol for sending data over
synchronous serial links. Cisco HDLC also provides a simple control protocol called Serial Line Address
Resolution Protocol (SLARP) to maintain serial link keepalives. Cisco HDLC is the default for data
encapsulation at Layer 2 (data link) of the Open System Interconnection (OSI) stack for efficient packet
delineation and error control.
Note
Cisco HDLC is the default encapsulation type for the serial interfaces.
When the encapsulation on a serial interface is changed from HDLC to any other encapsulation type, the
configured serial subinterfaces on the main interface inherit the newly changed encapsulation and they
do not get deleted.
Cisco HDLC uses keepalives to monitor the link state, as described in the
page

PPP Encapsulation

PPP is a standard protocol used to send data over synchronous serial links. PPP also provides a Link
Control Protocol (LCP) for negotiating properties of the link. LCP uses echo requests and responses to
monitor the continuing availability of the link.
LEDs on the Serial WAN Module
Cisco HDLC Encapsulation, page 41
PPP Encapsulation, page 41
Keepalive Timer, page 43
Frame Relay Encapsulation, page 44
4-43.
Cisco 800M Series Integrated Services Routers Software Configuration Guide
Color/ Status
Green
OFF
Green
OFF
Information About Configuring Serial Interfaces
Description
Indicates the interface status
and shows that line protocol is
up.
Shows that the line protocol is
down.
Indicates that the hardware
loopback status is configured
on the serial interface.
Indicates that loopback is not
configured.
"Keepalive Timer" section on
41