Argo AWIBS19 설치 지침 매뉴얼 - 페이지 10
{카테고리_이름} Argo AWIBS19에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo AWIBS19 18 페이지. Split air conditioner system
페이지 인쇄11- WIRED CONTROLLER INSTALLATION (IF PRESENT)
EN
A
MECHANICAL INSTRUCTIONS
•
Remove the rear panel of the wired controller.
•
Fix the panel to the wall in the desired position.
•
Make the electrical connections to the wired controller (see B).
•
Fix the controller to the rear panel previously installed on the wall.
2x 5,30
B ELECTRICAL CONNECTION
SINGLE UNIT CONNECTION
WIRED CONTROLLER
MULTI CONFIGURATION: UP TO 5 UNITS
WIRED CONTROLLER
REAR PANEL DIMENSIONS
114,60
57,30
41,70
41,70
INDOOR UNIT
GND
+12V
INDOOR UNITS
GND
+12V
R1,62
Before installation, please cut off the power supply
of the indoor unit to which the wired controller is
connected.
A
Multipolar wire:
B
Electric cable 12V dc; section: 4 x 0,75mm
ATTENTION!
When inserting or removing connectors, press gently
on the clamp to facilitate the operation.
A
B
UNIT 1
ATTENTION!
The indoor units controlled by the wired controller
must all be connected to the same outdoor unit.
A
UNIT 2...
B
A
... UNIT 5
B
10
2,50
WARNING
2
.