Cisco Quick Set C20 사용자 설명서 - 페이지 23

{카테고리_이름} Cisco Quick Set C20에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Quick Set C20 25 페이지. Tc7.3, english, december 2015
Cisco Quick Set C20에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 문제 해결 매뉴얼 (37 페이지), 설치 시트 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 매뉴얼 (32 페이지), 사용자 설명서 (48 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄
Cisco Quick Set C20 사용자 설명서
Cisco TelePresence System Profile-series, C-series codecs, Quick Set C20
Contents
Getting started

Controlling the cameras

During a call, you may control where your own camera is pointing and the zoom.
However, far end systems with remotely controllable cameras may also permit you to
control their camera's panning and zooming. This is called Far end camera control.
For video conferences with more than two participants, far end is an ambiguous term.
Consequently, far end camera control is not accessible unless you are in a point-to-point
call.
Controlling your own camera (near side)
1.
During a call, enter camera control mode by means of either of the
keys.
The display will now typically look like below, note that selfview has been activated
by the system (even if it was not in advance).
Access to far
Access to your
Access to your
end camera (if
own camera's
own camera
far end camera
presets, if defined.
settings.
is remotely
controllable).
D14582.04
User guide Cisco TelePresence Profile, C-series codecs, Quick Set C20, Nov. 2010.
All contents are Copyright © 2010 Cisco Systems, Inc. All rights reserved.
Making calls
Phone book usage
and
Arrow
Access to your
Exit this
own system's main
mode.
source setting.
In-call features
In-call features
•
Use the Arrow keys to change where the camera points and use the Zoom keys to
adjust the zoom.
Camera Presets, Camera settings and Main source are all explained in the section
Getting started.
Controlling the far end camera
1.
During a call, enter camera control mode by means of either of the
keys.
2.
Press the leftmost Function key to access the far end camera.
Back to near end
camera control.
3.
Far end camera control is restricted to controlling where the camera points and to
zooming. Nothing else. Use the arrow keys to change where the camera points and
the zoom keys to set the far end camera zoom.
36
User guide
Advanced settings
Contact us
and
Exit this
mode.
www.cisco.com
Arrow