DigiTech Hardwire SC-2 소유자 매뉴얼 - 페이지 11

{카테고리_이름} DigiTech Hardwire SC-2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech Hardwire SC-2 20 페이지. Digitech valve distortion owner's manual

Battery Operation

In the event that battery power is completely depleted, HardWire pedals

automatically switch into bypass. This eliminates the need to remove the

pedal from your pedal chain if the battery is dead. To replace the battery, do

the following:

Using the tip of a /" guitar cable, push in one of the Release Pins in on

either side of the Foot Switch, and remove it from the pedal chassis.

Remove the battery from the battery compartment and disconnect the

battery cable.

Connect a new battery to the battery cable and put it back in the bat-

tery compartment. Make sure the battery cable does not interfere with

the spring or pedal switch arm.

Place one hole of the Foot Switch over its corresponding pin.

Push the opposite pin in and lower the other side of the Foot Switch

into place over the depressed pin. Release the pin. When the Foot