DigiTech HOTROD 매뉴얼 - 페이지 10

{카테고리_이름} DigiTech HOTROD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech HOTROD 12 페이지. Distortion

Battery Replacement

1. Using the tip of a 1/4" guitar cable, push one of the release pins in on

either side of the pedal, and remove the pedal from the pedal chassis.

2. Remove the battery from the battery compartment and disconnect

the battery cable.

3. Connect a new battery to the battery cable and put it back in the

battery compartment. Make sure the battery cable does not interfere

with the spring or pedal switch arm.

4. Place one hole of the pedal over its corresponding pin.

5. Push the opposite pin in and lower the other side of the pedal into

place over the depressed pin. Release the pin. When the pedal is

properly fastened, both released pins are flush with the outer side of

the pedal.