DigiTech HYPERPHASE 매뉴얼 - 페이지 8

{카테고리_이름} DigiTech HYPERPHASE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech HYPERPHASE 12 페이지. Stereo phaser

11. Out 2 Jack

Connect this output to a second amplifier or mixer channel for stereo

phasing. Stereo is the best way to get the most effective stereo phaser

experience from the Hyper Phase pedal.

Connections

The Hyper Phase has a single input and a pair of outputs. Out 1 is used

if the Hyper Phase is being connected to only one amplifier or mixer

channel panned center. Out 2 is used for stereo operation. Connect

Out 1 to the first amplifier or mixer channel panned left and Out 2 to

the second amplifier or mixer channel panned right.

The Hyper Phase also has built-in CIT™ cabinet modeling that can be

enabled. This is a useful tool when running a distortion pedal into the

Hyper Phase and then running direct into a mixer or recorder. CIT

creates a guitar-through-an-amplifier sound without having to use a

guitar amp.

To Enable CIT™ Cabinet Modeling:

Press the pedal down and apply power (connect a guitar cable to the

Hyper Phase input or connect the PS200R power supply to the AC

adapter jack). CIT™ cabinet modeling has to be turned on each time

you apply power to the Hyper Phase.