Cisco TelePrescence SpeakerTrack 60 매뉴얼 - 페이지 18

{카테고리_이름} Cisco TelePrescence SpeakerTrack 60에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePrescence SpeakerTrack 60 22 페이지.

페이지 인쇄
Cisco TelePrescence SpeakerTrack 60 매뉴얼
Cisco TelePresence Precision 60 and SpeakerTrack 60
Contents
SpeakerTrack 60
Factory resetting the cameras
In order to reset the cameras, they have to be lifted from the
carrier tray, to access to the pin-hole button on the back panel
of the camera.
A factory reset should only be performed by a system administra-
tor or in contact with Cisco technical support.
The cameras will be reset to factory defaults, and all configuration
and logs will be erased.
It is not possible to undo a factory reset.
To perform a factory reset:
1. Remove the top cover of the SpeakerTrack 60 device.
2. Unscrew the wing nut that fastens one of the cameras.
3. Locate the pin hole button at the back of the camera.
See also
factory reset on
Precision60.
4. Use a pen or similar to press and hold the factory reset button
for 10 seconds.
5. The camerra LED will be lit red during the factory reset.
Do not unplug power.
6. When the factory reset is complete, the camera restarts and
the camera LED lights up.
7. Set the camera back to the tray and tighten the wing nut (see
picture 2 on the right).
8. Repeat steps 2-7 with the other camera.
9. Set back the top cover.
D15296.03 Cisco TelePresence Precision 60 and SpeakerTrack 60, APRIL 2016.
Introduction
Physical interface
Connecting the camera
1
2
3
18
Camera guide
Factory reset
Factory reset
Appendix
When replacing the camera, make
sure the pins on the base plate
fit the holes in the camera inter-
face plate.
Locate the pin-hole on the back
plate of the camera.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.