Argo DD DCI Series 사용 설명서 - 페이지 9

{카테고리_이름} Argo DD DCI Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo DD DCI Series 15 페이지. Air conditioner without outdoor unit

페이지 인쇄

ADJUSTING THE AIR FLOW DIRECTION

Make sure that the remote control unit has been turned on. Press

the FLAP button to select the sweep function or to choose one

of the six positions of the flap.

CAUTION

Do not move the flap with your hands when the air conditioner

is running.

Sweep function

The flap starts moving up and down to deliver air over the

sweep range.

NOTES

• The flap automatically closes when the unit is off.

• During the heating operation, the fan speed will be very low

and the flap will be in the horizontal position (position 4) until

the air being blown out of the unit begins to warm. Once the

air warms up, the flap position and fan speed change to the

settings specified with the remote control.

CAUTION

• Use the FLAP button on the remote control to adjust the

position of the flap. If you move the flap by hand, the factual

flap position and the flap position on the remote control

may no longer match. If this should happen, shut off the

unit, wait for the flap to close, and then turn on the unit

again; the flap position will now be normal again.

OPERATION WITHOUT THE REMOTE

CONTROL UNIT

If you have lost the remote control unit or it has troubles,

follow the steps below.

1. WHEN THE AIR CONDITIONER IS STOPPED

If you want to turn on the air conditioner push the

OPERATION BUTTON to select the desired mode (COOL

or HEAT).

NOTE

The air conditioner will start in HIGH fan speed.

The temperature setting is 25°C for cooling mode and

21°C for heating mode.

2. WHEN THE AIR CONDITIONER IS RUNNING

If you want to turn off the air conditioner push the

OPERATION BUTTON until the OPERATION lamp is

turned off.

Operation

button

To access the button it is

necessary to remove the

bottom panel.

NOTE

Power failure during operation.

In the event of power failure, the unit will stop. When the

power is resumed, the unit will restart automatically after

3 minutes.

TIPS FOR ENERGY SAVING

DO NOT:

Block the air intake and outlet of the unit.

If they are obstructed, the unit will not work well, and

may be damaged.

Let direct sunlight into the room. Use sunshades,

blind or curtain.

DO:

Always try to keep the air filter clean. A clogged filter

will impair the performance of the unit.

To prevent conditioned air from escaping, keep

windows, doors and any other openings closed.