Cisco TelePresence IX5000 매뉴얼 - 페이지 37

{카테고리_이름} Cisco TelePresence IX5000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence IX5000 44 페이지. Field-replaceable units and countryand region-specific power connectors
Cisco TelePresence IX5000에 대해서도 마찬가지입니다: 빠른 시작 사용 설명서 (15 페이지), 사용자 설명서 (26 페이지), 설치 매뉴얼 (36 페이지), 최초 설정 (40 페이지)

페이지 인쇄

Procedure

Step 1

Remove the bottom fascia by using the following procedure:

Note

While two people make this procedure easier, only one person is required.

While wearing gloves, grasp the fascia from the left side at the top corner and pull it outward. Let

the fascia swing outward from its hinge.

Set the left side of the fascia on the ground, leaving it upright. Do not twist or put undue stress on

the joints.

Move to the center of the system, pull the center of the fascia outward, and set that part on the

ground.

Take the right end of the fascia at the upper corner, pull it outward, and set that on the ground.

Leave the center and side sections at slight angles so that it remains upright.

Step 2

Power down the two PDUs mounted on the lower left and lower right display frames.

Step 3

Disconnect the cables from the codec.

Tip

A wiring diagram is useful to reconnect the cables.

Replacing a Codec—Part Number CTS-5K-ENCODER= or CTS-5K-HOSTCPU=

IX5000 Field-Replaceable Units and Country- and Region-Specific Power Connectors