Cisco TelePresence MX Series 시작하기 매뉴얼 - 페이지 17

{카테고리_이름} Cisco TelePresence MX Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MX Series 41 페이지. Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems
Cisco TelePresence MX Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (42 페이지)

페이지 인쇄

Cisco TelePresence Video Systems

Contents

Configuration using the remote control and on-screen menu*

Waking up the system

If there is no menu on screen, press

Home

control to show the menu.

If the system does not show a menu on screen:

• Make sure the monitor is connected and has been switched

on.

• Make sure the remote control has batteries installed.

• Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If there is still no menu on screen, make sure the monitor cable

is connected to the basic video output connector. If in doubt,

see the installation guide for your product.

* This section does not apply for EX Series and MX Series.

Back to task overview

D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.

Introduction

User interfaces

(

) on the remote

Confirguration

Configuration

Remote control and

on-screen menu

Getting Started Guide

Appendices

Contacts