DigiTech whammy ricochet 소유자 매뉴얼 - 페이지 6

{카테고리_이름} DigiTech whammy ricochet에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech whammy ricochet 10 페이지.

CLASSIC & CHORDS MODES

The Whammy Ricochet provides two modes of operation: Classic mode (the classic Whammy algorithm)

and Chords mode (the modern algorithm from the Whammy DT). The Classic mode is ideal for single

note soloing while the Chords mode is best suited for bending of full chords. The default mode out of the

box is Chords. The mode can be changed while the effect is on or off.

To change between Classic and Chords modes, follow these steps:

Set the MOMENTARY switch to the OFF position.

Press and hold the FOOTSWITCH for at least 3 seconds. The default mode out of the box is

Chords and the top 6 TRAJECTORY LEDs will light.

While still holding the FOOTSWITCH, move the RANGE switch to either the down position to

change to Classic mode (single TRAJECTORY LED lit) or move it to the up position to change to

Chords mode (top 6 TRAJECTORY LEDs lit). If the FOOTSWITCH is released before changing

modes, the effect will just remain enabled with no change to the mode.

Once the mode change is selected, release the FOOTSWITCH. The pedal will return to normal

operation and the effect will be enabled in the selected mode.

NOTE:

The selected mode will be retained after disconnecting power from the pedal.