Cisco Telepresence MX200 시작하기 매뉴얼 - 페이지 43

{카테고리_이름} Cisco Telepresence MX200에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Telepresence MX200 46 페이지. Table stand
Cisco Telepresence MX200에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (12 페이지), 빠른 참조 매뉴얼 (2 페이지), 문제 해결 매뉴얼 (37 페이지), 설치 매뉴얼 (6 페이지)

페이지 인쇄

Cisco TelePresence Video Systems

Contents

SX10 on-screen menu

Settings, Standby

mode and Do Not

Disturb feature

Place

calls

content

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Camera Control

To gain access to the Settings menu, move cursor to upper

left corner of the screen and press

Then navigate down to Settings and press

Configuration

The Settings shows the basic system information. In addition

on the remote control.

it provides access to the Setup assistant and to restart the

again.

system.

On the Setup assistant you can set the following:

Getting Started Guide

Appendices

• Language: Select a language for the user interface.

•

settings: Change the IPv4 settings, if those have not been

configured by autoprovisionig.

•

Provisioning

settings: Change provisioning settings, if those

have not been configured by autoprovisionig.

•

Test

microphone: If you are using an external microphone,

use this test to adjust its location.

•

Speaker

volume: Set the speaker volume for ring tones

and calls. If you cannot hear the test sound, check that

the volume on you monitor is switched on, and that the

cabeling is correct.

•

Default camera position:

Set the default camera position

for future calls.

•

Test

presentation: Connect your computer to the SX10, and

wait for the icon to change and mirror your computer screen.

Contacts