Cisco TelePresence MX300G2 매뉴얼 - 페이지 39

{카테고리_이름} Cisco TelePresence MX300G2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MX300G2 45 페이지. In-room control on touch 10
Cisco TelePresence MX300G2에 대해서도 마찬가지입니다: 매뉴얼 (45 페이지)

페이지 인쇄

Table of contents

To stop movement after long pressing, short press any button (stop

button is not really necessary)

Introduction

Remove an entire in-room control panel and icon

Create a user interface

If there is an in-room control panel on the video system then there

is also a corresponding in-room control icon, either in the Touch 10

status bar or as a button to the right of the call control buttons. Even

API for in-room control

if a panel is empty and contains no widgets, both the icon and the

panel will be visible.

Perform the following steps to remove the in-room control panel and

Widgets

icon from Touch 10:

Command reference

Troubleshooting

Tips and tricks

Examples

In-Room Control on Touch 10

for Cisco TelePresence

MX200 G2, MX300 G2,

MX700, MX800,

SX10, SX20, SX80

Collaboration Endpoint

software version CE8.2

D15358.02 - JULY 2016

www.cisco.com

a. Launch the in-room control editor from the video system's

web interface.

b. Select the panel to be removed (Global, Homescreen or In-

call)

c. Click

Recycle bin

( )in the lower right corner.