Cisco TelePresence MX700 매뉴얼 - 페이지 39

{카테고리_이름} Cisco TelePresence MX700에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MX700 45 페이지. Single camera on a free standing floor stand or a floor stand secured to the wall
Cisco TelePresence MX700에 대해서도 마찬가지입니다: 설치 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (12 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (29 페이지), 설치 매뉴얼 (32 페이지), 빠른 참조 매뉴얼 (2 페이지), 매뉴얼 (45 페이지), 설치 매뉴얼 (29 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 매뉴얼 (46 페이지)

Table of contents

To stop movement after long pressing, short press any button (stop

button is not really necessary)

Introduction

Remove an entire in-room control panel and icon

Create a user interface

If there is an in-room control panel on the video system then there

is also a corresponding in-room control icon, either in the Touch 10

status bar or as a button to the right of the call control buttons. Even

API for in-room control

if a panel is empty and contains no widgets, both the icon and the

panel will be visible.

Perform the following steps to remove the in-room control panel and

Widgets

icon from Touch 10:

Command reference

Troubleshooting

Tips and tricks

Examples

In-Room Control on Touch 10

for Cisco TelePresence

MX200 G2, MX300 G2,

MX700, MX800,

SX10, SX20, SX80

Collaboration Endpoint

software version CE8.2

D15358.02 - JULY 2016

www.cisco.com

a. Launch the in-room control editor from the video system's

web interface.

b. Select the panel to be removed (Global, Homescreen or In-

call)

c. Click

Recycle bin

( )in the lower right corner.