Cisco TelePresence MX700 매뉴얼 - 페이지 39

{카테고리_이름} Cisco TelePresence MX700에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MX700 45 페이지. Single camera on a free standing floor stand or a floor stand secured to the wall
Cisco TelePresence MX700에 대해서도 마찬가지입니다: 설치 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (12 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (29 페이지), 설치 매뉴얼 (32 페이지), 빠른 참조 매뉴얼 (2 페이지), 매뉴얼 (45 페이지), 설치 매뉴얼 (29 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄

Update the in-room control panel

Table of contents

When you export a new in-room control panel to the video system, the old

panel is overwritten and replaced by the new one.

Introduction

a. Launch the in-room control editor from the video system's web interface.

b. Create the in-room control panel you want, or import a previously saved

panel from file

Create a user interface

c. Click

API for in-room control

Remove the in-room control panel and icon

Widgets

If there is an in-room control panel on the video system then there is also an

in-room control icon in the Touch 10 status bar. Even if the panel is empty and

contains no widgets, both the icon and the panel will be visible.

Command reference

Perform the following steps to remove the in-room control panel and icon from

Touch 10:

Troubleshooting

a. Launch the in-room control editor from the video system's web interface.

b. Click Settings.

Tips and tricks

c. Click the

Examples

D15358.01 APRIL 2016

Collaboration Endpoint software

version 8.1

(Import > From

file).

Export > To

codec.

Delete

icon in the Remove configuration section.

Choose an in-room control icon

The icon to tap to open the in-room control panel appears in the status bar on

Touch 10. This icon is also known as the entry icon.

You can choose between two icons: a light bulb (default), or a generic utility

icon. We recommend that you use the light bulb for environmental controls like

lights and blinds, and the generic utility icon for other things.

a. Launch the in-room control editor from the video system's web interface.

b. Click Settings.

c. Click the entry icon that suits your needs.

d. Click

Export > To codec

to apply the change.

In-room control icon