DigiTech RP1000 설정 매뉴얼 - 페이지 6
{카테고리_이름} DigiTech RP1000에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech RP1000 12 페이지. Multi-effects switching system
DigiTech RP1000에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
Click VST audio System and select DigiTech RPxxx In/out (2) as the
2.
ASIO Driver (as shown below). DO NOT select DigiTech RPxxx In/Out (1).
.
Cubase
Switch then oK.
Mac PPC users: After selecting RPxxx In/Out (2) in the Device Setup panel, you may
need to verify that your device inputs are active. To do this, follow these steps:
1.
Select Device>VST Connections from the menu bar.
2.
When the VST Connections panel appears, click the Inputs tab.
.
The box under the audio Device column may say
does, click in this box and select DigiTech RPxxx In/out (2) to enable the
device inputs.
You are now ready to start recording with Cubase LE 4.
4
LE 4 will now ask you if you would like to switch the driver. Select
®
not Connected
"
If it
."