Cisco Telepresence MX800 매뉴얼 - 페이지 12

{카테고리_이름} Cisco Telepresence MX800에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Telepresence MX800 45 페이지. Wall-mounted mx800 single
Cisco Telepresence MX800에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지), 교체 매뉴얼 (46 페이지), 교체 매뉴얼 (47 페이지), 설치 매뉴얼 (30 페이지), 예비 부품 (24 페이지), 설치 매뉴얼 (16 페이지), 빠른 참조 매뉴얼 (2 페이지), 매뉴얼 (45 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 매뉴얼 (46 페이지)

Apply the in-room control panel to the video system

Table of contents

(Not available when using the offline editor. Instead, you should export the in-

room control panel to a file in order to save your work for later.)

Introduction

Apply the in-room control panel to the video system. You will see the results

immediately on the Touch 10.

• Choose

Create a user interface

API for in-room control

Check the result on Touch 10

(Not available when using the offline editor.)

Widgets

Tap the in-room control icon (light bulb or generic utility icon) in the Touch 10

status bar to open the in-room control panel.

Command reference

Troubleshooting

Tips and tricks

Examples

Which in-room control icon to display is defined under

you change to the other icon, you have to export the in-room control panel to

the video system again.

D15358.01 APRIL 2016

Collaboration Endpoint software

version 8.1

Export > To codec

Export the in-room control panel to file

Export the in-room control panel to a file, which can be imported back into the

editor at a later stage.

• Choose

If you are using the offline editor, this is the only way you can save your work for

later.

Exporting to file may also be useful as a way of creating a design template if you

are going to push the same in-room control panel to multiple video systems.

Files exported while connected to a video system are in the same format as

files exported from an offline editor. This means that any of these files can be

imported into an editor launched from a video system's web interface, and then

pushed to the video system's Touch 10.

In-room control icon

Settings

in the editor. If

Export > To file