Cisco TelePresence Profile 52 시작하기 매뉴얼 - 페이지 16
{카테고리_이름} Cisco TelePresence Profile 52에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Profile 52 42 페이지. Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems
페이지 인쇄Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
touch controller
Setting date, time and location
(when not set by a provisioning system)
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
The time is shown in the top right corner of the Touch
controller display.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces
Configuration
Configuration
1. Tap
More > Settings > Administrator settings > Date,
Time &
Location.
2. Tap
24h
or
12h
to select the
3. Tap dd.mm.yy,
mm.dd.yy
or
yy.mm.dd
Format
you prefer.
4. Select the
Time Zone
your system is in. Step through the
list of available zones by tapping the - or + signs.
5. Set
Date & Time Mode
to
Auto
to be regularly updated; otherwise, select Manual.
If you select Manual, enter the correct value for Hour,
Minute, Year, Month, and Day. Tap the plus and minus
signs to increase or decrease a value.
If you select Auto, the NTP server address can be
automatically obtained from the network (set the
Mode
to Auto) or you can enter the
yourself (set
NTP Mode
to Manual).
6. Tap
Save
to save the changes, or
saving.
7. Tap
Exit
to return to the home menu.
Appendices
Time Format
you prefer.
to select the
Date
if you want time and date
NTP
NTP Server
address
Undo
to leave without
16
www.cisco.com