Cisco TelePresence SX10 예비 사용자 설명서 - 페이지 6

{카테고리_이름} Cisco TelePresence SX10에 대한 예비 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence SX10 9 페이지. In-room control on touch 10
Cisco TelePresence SX10에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 사용자 설명서 (26 페이지), 빠른 매뉴얼 (2 페이지), 사용자 설명서 (34 페이지), 사용자 설명서 (29 페이지), 사용자 설명서 (38 페이지), 설치 매뉴얼 (8 페이지), 사용자 설명서 (2 페이지), 사용자 설명서 (37 페이지), 매뉴얼 (45 페이지), 매뉴얼 (45 페이지), 설치 매뉴얼 (2 페이지), 사용자 설명서 (34 페이지), 사용자 설명서 (5 페이지), 사용자 설명서 (38 페이지), 사용자 설명서 (38 페이지), 시작하기 매뉴얼 (46 페이지), 빠른 매뉴얼 (2 페이지)

Video calls

Placing calls

Move cursor to Contacts, if needed and press OK.

Make sure cursor is positioned as outlined and

press OK.

The virtual keyboard will now appear. Use

the cursor keys and the OK key to input

alphanumerical characters.

Any matches within the list of recent calls or the

directory will appear as you write. When all has

been keyed in, press the green Call key on the

remote control to place the call.

Press the red key on the remote control to terminate

the call.

About video calls and

video conferences

The traditional keypad (dialpad)

has been omitted on this system.

Instead, the list of Contacts (or

Recent) is used to key in the name,

address or number to the one to

be called.

Your input will be compared to the

contents of the list of Contacts

as well as the list of Recent calls.

Matches will appear as you write.

If you know that the one you are

going to call already exists in either

list, you may search by scrolling up

and down in that list and press OK

once the entry is located to invoke

the green Call box as shown in

Conferencing. Your video system

may be able to call more than one

to initiate a video conference.

To do this, start by calling the

first participant. As soon as that

call is up and running there will

be a selectable Add+ field. By

using this you may call the next

participant in the usual way.

Systems with MultiSite built-in

can call a maximum of three

video participants and one audio-

only participant. Systems using