DigiTech TALKER 사용자 설명서 - 페이지 4

{카테고리_이름} DigiTech TALKER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech TALKER 7 페이지.

Note: The Talker allows you to route your effect signal to a guitar amp and

a mixer simultaneously. When the Talker effect is being used, the output of

the Talker is all effect (100% "wet"). When the Talker is Bypassed, the mic

input is passed through to the PA output, and the instrument input to the

Amp output, which makes the Talker "invisible" to your recording or sound

reinforcement setup. If you have selected the Both option for effects routing,

you can balance the levels between the PA and the Amplifier with the PA

Level knob.

Note: If you are using a single output (Amp or PA only), and you don't hear

any effect sound, check that the Effects Routing Switch is set correctly.

Control Descriptions:

• Mic. In: adjusts the microphone input level.

• Instrument In: adjusts the instrument input level.

• Effect Out: controls the effect amount to the outputs.

Note: The above controls have no effect on Bypass levels.

• Program LEDs: indicate which Program the Talker is set to.

• Mic Clip LED: An LED flashing green with occasional orange

means your input is set properly; red indicates distortion.

• Instrument Clip LED: An LED flashing green with occasional

orange means your input is set properly; red indicates distortion.

• Bypass LED: A red LED means that the effect is bypassed.

• Program Switch: Toggles sequentially between the six Programs.

• Bypass Switch: Switches Bypass on or off.

In Bypass, the inputs are directly connected to their respective

outputs: instrument in > amp out, microphone in > P.A. out.

This is a hardwire bypass, as if the Talker isn't in the chain

when bypassed. The mic bypass will be at microphone levels.

• Power Input: a Harman Pro Group PS-750 power supply is included

with your Talker.

• Effect Routing Switch

Amp: effect out to amplifier only (P.A. output muted).

P.A.: effect out to P.A. system (mixer) (Amp output is muted).

Both: effect to both P.A. and amplifier simultaneously.

• P.A. Level: Active when Effect Routing is in the Both position, this

adjusts the level of effect to the P.A. output. This knob has no

effect when Effect Routing is set to either Amp or P.A.

Inputs:

• Instrument: unbalanced 1/4" connector (mono) - instrument input.

• Mic: balanced XLR connector (mono) - microphone input.

• Pad: switchable Microphone input pad (+4dB/-10dB).

Outputs:

• Amp: unbalanced 1/4" connector (mono) - connects effect to amplifier.

• P.A.: balanced XLR connector (mono) - connects effect to P.A. system.