Sony 10001 설치 매뉴얼 - 페이지 12
{카테고리_이름} Sony 10001에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony 10001 50 페이지. A/v multiplexer board, a/v demultiplexer board
Sony 10001에 대해서도 마찬가지입니다: 설치 매뉴얼 (28 페이지)
페이지 인쇄
1-6. Rack Mounting
. Loosely attaching the rail brackets
10. Slide the intermediate rail as shown in the figure, and
then loosely attach the rail bracket to the outer rail
with a plate nut (large) and two screws.
Plate nut (large)
Rail bracket
Outer rail
Intermediate rail
11. Slide the ball retainer in direction of the arrow, and
then loosely attach the rail bracket to the outer rail
with a plate nut (large) and two screws.
Plate nut (large)
Rail bracket
1-6
B4 x 8
Outer rail
Intermediate rail
Ball retainer
B4 x 8
. Attaching the outer rails
12. Loosely attach the outer rails to the 2U from bottom of
the 5U space in the rack for mounting this unit, with
the eight hexagon socket head cap screws, eight flat
washers, and four plate nuts (small).
n
Leave a space on the top or bottom of this unit by 1U
to reduce an increase in the internal temperature of this
unit.
Leave a space by 1U
By 5U
2U
Leave a space by 1U
13. As shown in the following figure, adjust each front-
side position of outer rails on both sides (left and right)
so that the distance from the surface of the rack to tip
of the rail becomes within the range of 50 to 55
millimeters.
14. Fully tighten the eight screws (B4 x 8) fixing the four
rail brackets.
Tightening torque: 120 x 10
Rack
Rail bracket
50 to 55 mm
Rack angle
Plate nut (small)
Rail
Flat washer
Hexagon socket
head cap screw
L-shaped hexagon wrench
_2
N . m {12.2 kgf . cm}
Outer rail
B4 x 8
DNW-75/75P
DNW-65/65P