Sony BRC-300 사양

{카테고리_이름} Sony BRC-300에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-300 8 페이지. 3ccd color video camera
Sony BRC-300에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 브로셔 및 사양 (8 페이지), 사양 (8 페이지), 브로셔 (8 페이지), 브로셔 (8 페이지), 브로셔 및 사양 (8 페이지), 명령 목록 (23 페이지)

페이지 인쇄

Partner: Sony

Model: BRC-300

Device Type: Camera

GENERAL INFORMATION

SIMPLWINDOWS NAME:

CATEGORY:

VERSION:

SUMMARY:

GENERAL NOTES:

Sony BRC-300 with Joystick Controls and Picture Adjustments

Camera

3.0

This module will control the Sony BRC-300. It uses 2-way RS232 communications,

stores up to 25 presets on the Crestron system, and allows camera control using

joysticks as well as standard buttons. Either the Crestron CPC-2000 or C2N-CAMIDJ

Joystick Controller can be used, however they cannot both be used in the same

system. Note that the C2N-CAMIDJ is not supported on systems prior to the 2-Series

processors. White Balance and Exposure controls are also included.

There are two ways to control the camera using the digital Pan/Tilt inputs. One way

automatically changes speeds the longer you hold the input high. The pan inputs

have three speeds. The tilt inputs have two speeds. The speed changes occur at

two-second intervals. It is possible to enter the same speed for the speed

parameters, thus eliminating the speed changes. Also, selecting the speed of default

will use the default speeds preprogrammed into the module. The digital inputs for

zoom will also automatically change speeds.

The second way uses proportional pan tilt speeds. The current zoom position is

determined. Then the speed is set based on that zoom position.

Saving a preset is a three step process:

Move the camera to the desired position

Press Save (the Save_Fb will go high)

Press the preset you wish to save the location to.

To recall a preset, just press the preset number.

There are two sets of joystick inputs that can be used. The signals prefaced with

CPC-2000 are designed to be connected to the corresponding signals on a Crestron

CPC-2000A Joystick Controller. The signals prefaced with C2N-CAMIDJ are designed

to be connected to the corresponding signals on a Crestron C2N-CAMIDJ Joystick

Controller. Note that you cannot use both the CPC-2000A and the C2N-CAMIDJ in

the same system with this module.

Unused inputs can have a "0" assigned to them. Unused outputs should have unique

commented out signal names assigned to them.

It is very important to pulse the Start_RS232 input before attempting to use any

functions on this module. This will request the maximum speeds that the camera will

support. It will also request the firmware version in the camera. This must be done

once for each camera. After the maximum speeds have been requested, they will be

saved to non-volatile RAM.

Speeds are set on the CPC-2000 by using the Speed knobs. On the C2N-CAMIDJ,

two sets of speeds can be saved – High and Low. Speeds are set on the C2N-

CAMIDJ as follows:

Select high or low speed by pressing the top (high) or bottom (low) button

on the top of the joystick handle. The corresponding High or Low LED will

illuminate.

Press the function that you want to set the speed for (Zoom, Pan, Tilt). The