Sony BRC-H800 펌웨어 업그레이드 매뉴얼 - 페이지 2

{카테고리_이름} Sony BRC-H800에 대한 펌웨어 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-H800 3 페이지.

An IP address must be set for the camera to upgrade the

firmware. For how to set an IP address of the camera,

refer to "RM-IP10 Setup Tool Guide."

You will also need a PC as you use a Web browser to

upgrade the firmware.

Notes

• Do not turn off the camera while you are upgrading the

firmware.

• It takes approximately 10 minutes to upgrade the

firmware. You cannot access the camera while the

upgrading is in progress. You also will not see any

image while the upgrading is in progress.

Before starting the

operation

Setting-up the PC

One of the following system configurations is required

for the PC:

Windows 8.1 Pro (32-bit version, 64-bit version)

Windows 10 Pro (32-bit version, 64-bit version)

Web browser

Windows Internet Explorer Ver. 11.0

Notes

• In the case of Windows 8.1, use the Internet Explorer

desktop user interface (desktop UI) version.

• Turn off tablet mode when using Windows 10.

• Every page is optimized for Internet Explorer in

Medium font size.

• The Web page displayed when you log in to the

camera is made using JavaScript. The Web page may

not display correctly if your computer uses certain

software, such as anti-virus software.

Accessing the camera using the

Web browser

Start the Web browser on the computer and type the IP

address of the camera in the address bar.

A user ID and password authentication is required to

access the camera. The user ID and factory-set password

of the camera are as follows:

User name: admin

Password: Admin_1234