Sony BRC-X400 매뉴얼 - 페이지 4

{카테고리_이름} Sony BRC-X400에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-X400 15 페이지. Srt introduction
Sony BRC-X400에 대해서도 마찬가지입니다: 명령 목록 (41 페이지), 기술 매뉴얼 (15 페이지)

페이지 인쇄

Manufacturer: Sony Imaging Products & Solutions Inc.

Model: BRC-X400/SRG-X series

Device Type: Camera

preset_mode_std, preset_mode_ptzf,

preset_mode_trace

preset_freeze, preset_normal

preset_set, preset_recall, preset_reset

preset_number_up,

preset_number_down

preset_speed_up, preset_speed_down

preset_compatible, preset_separate,

preset_common

wb_mode_auto, wb_mode_indoor,

wb_mode_outdoor, wb_mode_one_push,

wb_mode_ATW, wb_mode_manual

wb_one_push_trigger

wb_offset_reset

wb_offset_up, wb_offset_down

r_gain_reset

15 Volvo Drive · Rockleigh, NJ 07647

800.237.2041 / 201.767.3400

Press to set the preset operation mode to either "standard", "ptzf" or "trace" as

follows.

"standard": Save/restore its PTZF positions as well as its camera configuration

parameters such as exposure, white balance etc.

"ptzf": Save/restore its PTZF positions only

"trace": Preset save/call operations are mapped to PTZ Trace. This is supported in

software version 2.00.

The other signals that are not last set will be changed to 0 via corresponding

feedback control signals.

Press to set preset recall mode to either freeze or normal. The other signal will be

changed to 0 via corresponding feedback control signal.

Press to save/recall/reset the preset to a selected preset position number.

Increment/decrement preset number for save/recall/reset operation.

Increment/decrement preset position operation speed.

Press to set preset speed mode to either compatible, separate or common whose

details are shown below. The other signals that are not last set will be changed to 0

via correspondent feedback control signals.

"compatible": The same effect as "separate" in case that the preset operation is

controlled under VISCA and/or VISCA over IP protocol. However, be sure that it

should be configured to this mode when you use the preset position function by

way of CGI protocol as well.

"separate": Preset operation speed is set when saving the preset position using

preset_set signal. Thus, the speed configuration should be per position basis.

"common": Preset operation speed is uniquely configured regardless of

recalled/saved preset position number.

Press to set white balance mode to either auto, indoor, outdoor, one push, ATW

(Auto Tracing White balance) or manual. The other signals that are not last set will

be changed to 0 via corresponding feedback control signals.

Press to perform one push WB. This is possible when the White balance mode is

set to one push beforehand.

Press to reset white balance offset.

Increment/decrement white balance offset.

Press to reset red gain.

For more information please contact our Crestron Application Market team at

[email protected]. The information contained on this document is privileged

and confidential and for use by Crestron Authorized Dealers, CSP Members, A+ Partners

and Certified Integrated Partners only. Specifications subject to change without notice.

http://application.market.com