Sony BRC-X400 명령 목록 - 페이지 41

{카테고리_이름} Sony BRC-X400에 대한 명령 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-X400 41 페이지. Srt introduction
Sony BRC-X400에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지), 기술 매뉴얼 (15 페이지)

페이지 인쇄
Sony BRC-X400 명령 목록
Camera IP Setting
Command
The following commands are provided for
setting an IP address and a camera name for
BRC/SRG series cameras.
No.
Name
1
Setting Protocol:
Inquiry
2
Setting Protocol:
Inquiry reply
3
Setting Protocol:
Network setting
4
Setting Protocol:
Network setting
reply
The network setting of the camera is performed
as communication sequence in the following.
Connect the computer that configures the
settings to the same segment as the camera.
1
Inquiry
The controller sends the inquiry packet to
the broadcast address (255.255.255.255),
specified port number (52380) of UDP. The
camera replies as the inquiry reply packet.
2
Network setting
The controller sends the network setting
packet to the broadcast address
(255.255.255.255), specified port number
(52380) of UDP. The camera sees the MAC
address unit in the packet and returns ACK as
the network setting reply if it is the request
for the camera.
If the camera fails to set, it returns NACK as
the network setting reply.
Description
The controller inquires the
network setting for the
camera.
The camera replies
according to the inquiry
from the controller.
The controller sets the
network setting of the
camera.
The camera replies
according to the network
setting of the controller.
Command
Inquiry
UDP
Broadcast address
(255.255.255.255)
Specified port number
(52380)
Inquiry reply
UDP
Broadcast address
(255.255.255.255)
Specified port number
(52380)
Network setting
UDP
Broadcast address
(255.255.255.255)
Specified port number
(52380)
Network setting reply
UDP
Broadcast address
(255.255.255.255)
Specified port number
(52380)
*1
Uses the ASCII code.
*2
Uses the ASCII code. Returns as "NAK:**-**-**-**-**-**" for
NAK.
*3
Uses the ASCII code. Returns by adding the detail message, if
necessary.
Notes
• The camera name (NAME) is up to 8 characters
of alphanumeric characters and blank.
• Settings cannot be changed when WRITE of
Inquiry reply is set to off. WRITE can be set to
off by the CGI command with this camera.
Improper changes can be prevented by turning
WRITE to off after setting the IP address of the
camera.
41
Data
02
*1
ENQ:network
FF
03
02
*1
MAC:**-**-**-**-**-**
FF
*1
MODEL:IPCARD
FF
*1
SOFTVERSION:**.**.**
FF
*1
IPADR:***.***.***.***
FF
*1
MASK:***.***.***.***
FF
*1
GATEWAY:***.***.***.***
FF
*1
NAME:xxxxxxxx
FF
*1
WRITE:on
FF
03
02
*1
MAC:**-**-**-**-**-**
FF
*1
IPADR:***.***.***.***
FF
*1
MASK:***.***.***.***
FF
*1
GATEWAY:***.***.***.***
FF
*1
NAME:xxxxxxxx
FF
03
02
*2
ACK:**-**-**-**-**-**
*3
"xxxx"
FF
03