Sony BRC-X400 기술 매뉴얼 - 페이지 5

{카테고리_이름} Sony BRC-X400에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-X400 15 페이지. Srt introduction
Sony BRC-X400에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지), 명령 목록 (41 페이지)

페이지 인쇄

Technical Guide | BRC-X400/SRG-X400/X120

Pre-configuration Settings

This section describes some pre-configuration settings you will need before activating the SRT

function for the cameras.

3.1. HTTP/RTSP setting

The HTTP/RTSP communication setting need to be enabled in order to communicate via network

before the SRT function of the camera is enabled. Please refer to the Operation Manual of the target

camera, and set the HTTP/RTSP communication setting.

Ref).

The section of [Adjusting and Configuring the Camera through On-Screen Menus] – [SYSTEM

Menu] - [HTTP/RTSP] of the Camera's Operation Manual.

The section of [Accessing the Camera from a Web Browser] – [Enabling HTTP/RTSP in the

Camera] of the Camera's Operation Manual.

3.2. Set IP address by using the RM-IP Setup Tool

For IP communication, the IP address needs to be set. You can use RM-IP Setup Tool to assign IP

address to the camera. Please refer to the RM-IP Setup Tool Guide for more details.

[Note] The DHCP setting cannot be enabled from the RM-IP Setup Tool.

3.3. Change the default password

When the procedure of 3.1 and 3.2 are performed, HTTP access to the camera is available. Please

change the default password (initial password) according to the Operation Manual of the Camera.

Ref).

The section of [Accessing the Camera from a Web Browser]-[Changing the Initial Password] of the

Camera's Operation Manual.

Sony

SRT introduction

Version 1.0