DigiTech XC0438 사용자 설명서 - 페이지 13
{카테고리_이름} DigiTech XC0438에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiTech XC0438 16 페이지. Smart wi-fi weather station lcd colour display
페이지 인쇄
ACTIVATING ALARM FUNCTION
1 . In normal mode, press the [ MODE / ALARM ] key to show
the alarm time for 5 seconds .
2 . When the alarm time displays, press the [ MODE / ALARM ]
key again to activate the alarm function.
When the clock reaches the alarm time, the alarm sound will start .
Where it can be stopped by the following operation:
- Auto-stop after 2 minutes of alarming if without any operation and the alarm will activate again on
the next day .
- By pressing the [ ALARM / SNOOZE ] key to enter snooze, the alarm will sound again after 5
minutes .
- By pressing and hold the [ ALARM / SNOOZE ] key for 2 seconds to stop the alarm and it will
activate again in the next day
- By pressing [ MODE / ALARM ] key to stop the alarm and the alarm will activate again on the
next day .
NOTE:
- The snooze could be used continuously for 24 hours.
- During the snooze, the alarm icon "
WIRELESS SENSOR SIGNAL RECEIVING
1 . The console display signal strength for the wireless sensor(s), as per table below:
Signal strength of wireless
sensor channel
2 . If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear . The temperature and humidity will display "Er" for the corresponding channel .
3 . If the signal does not recover within 48 hours, the "Er" display will become permanent. You
need to replace the batteries and then press the [ SENSOR / WI-FI ] key to pair up the
sensor again .
VIEW THE OTHER CHANNELS (OPTIONAL FEATURE WITH ADD ON EXTRA SENSORS)
This console is capable to pair with 7 wireless sensors. If you have 2 or more wireless sensors,
you can press the [ CHANNEL ] key to switch between different wireless channels in normal
mode, or press and hold the [ CHANNEL ] key for 2 seconds to toggle auto-cycle mode to
display the connected channels at a 4 second interval.
During auto-cycle mode, the
console's display . Press the [ CHANNEL ] key to stop the auto cycle and display the current
channel .
TEMPERATURE / HUMIDITY FUNCTION
- The temperature and humidity readings are displayed on the channel and indoor section .
- Use the [ °C / °F ] key to select the temperature display unit .
- If the temperature / humidity is below the measurement range, the reading will show "LO" . If the
temperature / humidity is above the measurement range, the reading will show "HI".
COMFORT INDICATION
The comfort indication is a pictorial indication
based on indoor air temperature and humidity in
an attempt to determine comfort level.
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity.
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F).
" will keep flashing.
No signal
icon will show on the wireless sensor channels section of the
13
Alarm off
Weak signal
Too cold
Comfortable
Alarm on
Good signal
Too hot