Sony DCR-HC30 - Handycam Camcorder - 680 KP 애플리케이션 매뉴얼 - 페이지 11
{카테고리_이름} Sony DCR-HC30 - Handycam Camcorder - 680 KP에 대한 애플리케이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony DCR-HC30 - Handycam Camcorder - 680 KP 44 페이지. Sony handycam dcr-hc30: release note
Sony DCR-HC30 - Handycam Camcorder - 680 KP에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 시 참고 사항 (2 페이지), 릴리스 노트 (2 페이지)
페이지 인쇄Using the USB cable (supplied)
when viewing pictures on a tape
Before following the procedures below, make
sure you have installed Picture Package on your
computer (p. 8).
to USB jack
to USB jack
Notes
b
• Do not connect your camcorder to the computer
at this point.
• The computer may not recognize the camcorder
if you connect them with the USB cable (supplied)
before turning on your camcorder.
1
Turn on the computer.
Close down all applications running on the
computer.
For Windows 2000/Windows XP
Log on as Administrators.
2
Prepare the power source for your
camcorder, then slide the POWER
switch to select the PLAY/EDIT mode.
Use the supplied AC Adaptor as the power
source.
The name of the power switch on the
camcorder varies depending on the model.
Tip
z
• Slide the POWER switch to select the
CAMERA-TAPE mode, and you can view
USB cable
(supplied)
pictures that your camcorder is seeing on the
computer - USB Streaming.
3
Set [USB STREAM] in the menu
settings of your camcorder to on.
The procedure of the menu settings varies
depending on the model.
4
Connect the USB cable (supplied) to
the USB jack on the camcorder.
Fully insert.
The location of the USB jack varies
depending on the model. Refer to the
separate Camera Operations Guide
supplied with your camcorder for the
location.
For the model that is supplied with the
Handycam Station, connect the USB cable
to the USB jack on the Handycam Station,
then set the USB ON/OFF switch to ON.
5
Connect the other end of the USB cable
to the USB jack on your computer.
It may take some time for the computer to
recognize the camcorder when you connect
the USB cable for the first time.
Then [USB Streaming Tool] starts up.
If [Found New Hardware Wizard] appears,
click [Continue Anyway] and complete the
installation.
For Windows 2000/Windows XP
When the dialogue box prompting you to
confirm the digital signature appears, select
[Yes] if you use Windows 2000 or select
[Continue Anyway] if you use Windows
XP.
Connecting to a Windows computer
,continued
11