Cisco TelePresence System C20 Plus 시작하기 매뉴얼 - 페이지 38
{카테고리_이름} Cisco TelePresence System C20 Plus에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence System C20 Plus 46 페이지. Telepresence conference system
Cisco TelePresence System C20 Plus에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (35 페이지), 시작하기 매뉴얼 (32 페이지)
페이지 인쇄
Cisco TelePresence Video Systems
Contents
Call key
Press the Call key to place a
call, and to accept an incom-
ing call.
Use the Call button as a short-
cut to Recent Calls when the
Call menu is not visible.
Clear
Press the Clear key to remove
characters in a text field.
Waking up the system
To wake up the system just pick up the remote control or press any key. You may have to point
the remote control toward the system/camera to make sure it discovers you.
Home key
Press the
Home
(
) key
to open the Home menu
on screen.
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction
User interfaces
End call / Standby
Press the End Call key to
reject an incoming call, to
end an ongoing call or—when
idle—to go into standby mode.
When navigating in the menu
the key is used to exit the
menu system.
Press and hold this key to
have the system enter standby
mode.
Rubber line sensors
When you pick up the remote
control and touch the rubber
line sensors along the sides of
the remote control, the system
wakes up.
Configuration
Alphanumeric keypad
The keypad behaves in a similar way to the keypad on a mobile phone.
0-9, a-z, period (.), @,
space, *
Press a key repeatedly
to toggle between the
options displayed on that
key.
IR sensor range (DIP switch setting)
The IR sensor has a short and long range. When video conference systems are placed close to each
other, you may find it convenient to use the short range to avoid interfering with the other systems.
Open the battery cover and remove the batteries to set the DIP switch.
• Short range (1 m / 3 ft): Move the DIP switch down.
•
Long range: Move the DIP switch up.
The DIP switch
38
Getting Started Guide
Appendices
Appendices
Contacts
Press and hold the # key
to toggle between lower
and upper case characters
and numbers (depending
on context).
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
abc/123 #