Cisco TelePresence System Codec C40 문제 해결 매뉴얼 - 페이지 21

{카테고리_이름} Cisco TelePresence System Codec C40에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence System Codec C40 37 페이지. Telepresence c series telepresence mx series telepresence sx series telepresence ex series
Cisco TelePresence System Codec C40에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (42 페이지), 사용자 설명서 (48 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄

Cisco TelePresence System Codec C40 문제 해결 매뉴얼

Security

Web Page (HTTP/HTTPS)

Access to the web management of the system is enabled on HTTp and HTTpS as default. HTTp access can be

disabled from

Configuration -> System Configuration -> NetworkServices -> General Settings -> HTTP Mode

and set it to Off.

Default user account

The video system is delivered with a default user account with full credentials. The user name is

admin, and initially, no password is set for the default user.

We strongly recommend that you set a password for the admin user, and to any other user with similar

credentials, to restrict access to system configurations.

Make sure to keep a copy of the password in a safe place. You have to factory reset the unit if you

have forgotten the password.

Root user account

The root user account is disabled by default in TC6 and should not be enabled unless you are instructed

to do so by support. For details on checking the status of root account, disabling and enabling it please

see"Appendix B – Gaining root access to your system" on page 33.

Menus – restricting access to configuration changes

To restrict access to the available menus, you can set a menu password on the system. This affects

the on-screen menus for remote control users and the Touch interface for those using a Touch panel.

Currently this is only possible from the command line. SSH to the system. log in as admin and enter

the command:

xCommand SystemUnit MenuPassword Set Password: "ABC"

Where ABC is the password that must be entered in order to be able to access the configuration

settings on the GUi interfaces.

Once enabled you will be asked for this password to access the configuration areas of the interface.

D15029.01 Troubleshooting Guide TC6.0, April 2013.

Web page restrictions

Web access can be restricted as well. To do this go to

The new user will have access to the configuration page, but will not have the ability to save any changes

to the configuration.

Troubleshooting Guide TC6.0

Configuration -> User Administration -> Add New User.